Description

Cool multicoloured owl lamp.

From the original design I added some screws and bolts to they eye pupils to attach a neo pixel ring, and put a hole in the but to feed a usb cable through.

I am using a ESP32 development board with WLED software to power the lights and am really happy with the result, we use it for a night light for our oldest son.

Also modified the top and base a bit as they had 90 degree overhangs which causes extrusion in mid air. There is still a bit of mid air extrusion, the results can be seen in one of the picture above, but print job does finish and the messy bit is hidden inside.

Print Settings

Best printed at lower layer height (.12) as some of the overhangs are quite steep.

No supports needed.

I printed with 2 shells and 10% infill.

The head is not completely flat on the bottom, the front is raised a little but it still prints fine.

Feet and Beak require a small brim